Table of Contents
Advertisement
Configuring Multicast VPN
Command or Action
Step 6
nsf lifetime seconds
Example:
RP/0/RP0/CPU0:router(config-igmp)# nsf lifetime
30
Step 7
commit
Step 8
show {igmp | mld} [ old-output] nsf
Example:
RP/0/RP0/CPU0:router# show igmp nsf
Step 9
show mfib [ipv4 | ipv6] nsf [location node-id]
Example:
RP/0/RP0/CPU0:router# show mfib nsf
Step 10
show mrib [ipv4 | ipv6] [old-output] nsf
Example:
RP/0/RP0/CPU0:router# show mrib nsf
Step 11
show pim [ipv4 | ipv6] nsf
Example:
RP/0/RP0/CPU0:router# show pim nsf
Configuring Multicast VPN
•
• "Configuring BGP to Advertise VRF Routes for Multicast VPN from PE to PE" (required)
• Configuring an MDT Address Family Session in BGP as a PE-to- PE Protocol (optional for PIM-SM
• Configuring a provider-edge-to-customer-edge protocol (optional)
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
100
Enabling a VPN for Multicast Routing, on page 101
See the module "Implementing BGP on Cisco IOS XR Software in Cisco IOS XR Routing Configuration
Guide for the Cisco CRS Router.
MDT groups; required for PIM-SSM MDT groups)
See the "Configuring an MDT Address Family Session in BGP" section in Cisco IOS XR Routing
Configuration Guide for the Cisco CRS Router.
Implementing Multicast Routing on Cisco IOS XR Software
Purpose
(Optional) Configures the NSF timeout value for multicast
forwarding route entries under the IGMP or MLD process.
(Optional) Displays the state of NSF operation in IGMP or
MLD.
(Optional) Displays the state of NSF operation for the MFIB
line cards.
(Optional) Displays the state of NSF operation in the MRIB.
(Optional) Displays the state of NSF operation for PIM.
(required)
Advertisement
Table of Contents
