Setting The System Clock And Time Zone; Verifying And Saving Your Clock And Time Zone Configuration; Configuring Network Time Protocol Support - Cisco ASR 5500 System Administration Manual

Setting the System Clock and Time Zone

Setting the System Clock and Time Zone
Use the following command example to configure the system clock and time zone:
clock set date
configure
clock timezone timezone
end
Notes:
• Enter the date and time in the format YYYY:MM:DD:HH:mm or YYYY:MM:DD:HH:mm:ss.
• Refer to the online Help for the clock timezone command for a complete list of supported time zones.
• The optional local keyword indicates that the time zone specified is the local timezone.
• Daylight Savings Time is automatically adjusted for time zones supporting it.
Save your configuration as described in the Verifying and Saving Your Configuration chapter.

Verifying and Saving Your Clock and Time Zone Configuration

Enter the following command to verify that you configured the time and time zone correctly:
show clock
The output displays the date, time, and time zone that you configured.

Configuring Network Time Protocol Support

This section provides information and instructions for configuring the system to enable the use of the Network
Time Protocol (NTP).
Important
Many of the services offered by the StarOS require accurate timekeeping derived through NTP. If the time
reference(s) used by StarOS are not accurate, the services may be unreliable. For this reason it should be
assumed that normal system operation requires that NTP be configured.
The system uses NTP to synchronize its internal clock to external time sources (typically GPS NTP sources,
or other Stratum 2 or 3 servers, switches or routers).
The system should have:
• NTP enabled.
• NTP configured for use in the local context only. Use of other contexts (which can be specified in the
• NTP configured for at least three external NTP servers. With three or more servers, outlyers and broken
ASR 5500 System Administration Guide, StarOS Release 21.5
26
time
:
[
Configure the system clock and time zone prior to implementing NTP support. This greatly reduces the
time period that must be corrected by the NTP server.
enable configurable) will cause issues.
or misconfigured servers can be detected and excluded. Generally, the more servers the better (within
reason).
local
]
System Settings