Nmea Interface; Cabling; Nmea Data Transmission To Other Equipment - Raymarine ST5000+ Owner's Handbook Manual

Chapter 5: Installation
4. Turn the helm to port to counter the rudder movement.
Note: Monitor the reservoir tank at all times and top up with the
manufacturers recommended fluid as required. If air is left in the
system the steering will feel spongy, particularly when the wheel is
rotated to the hardover position.

5.7 NMEA interface

ST5000 Plus will accept navigation data in the NMEA format for use
in Track Control. The required data formats are shown in the table at
the end of this section.

Cabling

The NMEA data port is on the rear of the ST5000 Plus and should be
connected to a Position Transducer or Wind Instrument.

NMEA data transmission to other equipment

If you wish to transmit NMEA information to other equipment a
SeaTalk Interface (Z290) should be installed.
Navigator
with NMEA output
Red
(Data In +ve)
67
Blue
(Data In -ve)
D3374-1