Flush Mounting - Raymarine ST5000+ Owner's Handbook Manual

Chapter 5: Installation

Flush mounting

To fit a flush mount control head:
1. Ensure that the panel on which you intend to mount the control
2. Apply the flush mount template (supplied near the rear of this
3
4. Peel off the protective sheet from the self-adhesive gasket (4) then
5. Screw the two fixing studs (1) into the threaded sockets on the rear
6. Pass the cables (SeaTalk, power, compass etc.) through the
7. Mount the assembled control head, studs, and gasket into the
8. Locate the bracket (6) onto the fixing studs and secure the
head is between 3 mm and 20 mm thickness.
handbook) to the selected location and mark out the aperture into
which the control head will sit.
Cut out the aperture (3) for the control head and remove the
template.
stick the gasket into position on the rear of the control head bezel.
of the control head.
bulkhead and connect them to the appropriate terminals (see
relevant subsection for connection details).
panel.
assembly to the panel with the thumb-nuts (5). Tighten the thumb
nuts BY HAND. Do NOT use a wrench.
4 3
41
1 6 5
D4585-1