Heading Alignment; Heading Mode; Bar Selection; Data - Raymarine ST5000+ Owner's Handbook Manual

Chapter 4: Customising the ST5000 Plus
Heading alignment (ALIGN HDG)
The heading alignment screen is used to align the autopilot compass
with the ship's compass.
• Steer your vessel onto a known heading.
• Adjust the displayed heading using the -1, +1, -10 and +10 keys.
• Check the autopilot display on various headings and adjust as
Heading mode (HDG MAG/TRUE)
Select either magnetic or true heading mode. When heading data is
displayed in normal operation, the screen indicates whether true or
magnetic mode has been selected.
Bar selection (RUDD BAR/STEER BAR/NO BAR)
Select the type of bar graph that is shown at the bottom of the displays.
The options are as follows:
RUDD BAR: This shows the rudder position, and is the default setting for
Hydraulic systems. Note that a rudder reference transducer is required
for accurate rudder position information.
STEER BAR: This is the default setting for Sterndrive systems. The bar
graph is used as follows:
Mode
Standby
Auto compass
Track
Data pages (DATA PAGE)
The next 7 User Setup pages allow the settings for the Data Pages to be
modified. These are the SeaTalk/NMEA data pages available during
normal operation (see section 2.5).
Each setup page initially shows the title DATA PAGE. After 1 second,
this changes to the title of the data currently set for that page.
necessary.
Bar
Rudder bar for systems with a rudder reference transducer
Heading error bar
Cross Track Error (XTE) bar
25