Can I Cancel The Process - Raymarine ST5000+ Owner's Handbook Manual

75
Chapter 6: Post Installation Procedures
D3452-1

Can I cancel the process?

You can abort the correction process by pressing the DISP key to move
on to the Deviation screen.
If you wish to attempt deviation correction again, you can step back to
the Swing Compass page or keep pressing disp to cycle through the
calibration options until the page is displayed again. (To step back to
the previous screen, press and hold the disp key for one second. You
can only do this within two seconds of advancing to the current
screen.) Repeat the procedure from step 4.
6. Keep turning your boat until the unit beeps and the DEVIATION
screen is displayed.
D3458-1
This shows the maximum deviation detected, and indicates that
compass correction has been completed successfully.
Note: If the deviation value exceeds 15° or a deviation value is not
displayed at all, you should consider moving the fluxgate compass to a
better location.
7. Press the disp key to move on to the Heading Alignment page.