Nmea Interface; Cabling; Nmea Data Transmission To Other Equipment - Raymarine ST5000+ Owner's Handbook Manual

Chapter 5: Installation

5.6 NMEA interface

Cabling

NMEA data transmission to other equipment

ST5000 Plus will accept navigation data in the NMEA format for use in
Track Control and Windvane modes. The required data formats are
shown in the table at the end of this section.
The NMEA data port is on the rear of the ST5000 Plus and should be
connected to a Position Transducer or Wind Instrument.
Navigator
with NMEA output
If you wish to transmit NMEA information to other equipment a
SeaTalk Interface (Z290) should be installed.
Red
(Data In +ve)
57
Blue
(Data In -ve)
D3374-1