Control Functions; Control Panel - Jacuzzi J-315 Owner's Manual

below 4.0 ppm to protect pillows and plastic knobs from chemical
attack.
CAUTION: Never leave your spa unattended for any reason
while the cover is open and accessible to small children and
animals.
CAUTION: To prevent the unlikely possibility of contracting a
waterborne illness, maintain water chemistry within step 6 pa-
rameters. If you or other bathers experience such a condition,
discontinue use and seek medical attention.
15. Establish a sanitizer reading between 3.0-4.0 ppm Chlorine or 2.0-
4.0 ppm Bromine, then allow the spa to set undisturbed for 8 hours.
Retest water after 8 hours to determine if sanitizer levels are stable.
If sanitizer levels are stable, your spa is ready for use. To ensure
healthy water conditions, always maintain a constant sanitizer read-
ing within the levels recommended by the Association of Pool And
Spa Professionals/USA printed on the inside cover of this manual.
If sanitizer levels are not stable at this time, it will be necessary to
repeat this procedure in its entirety (steps 1-15) until stable sanitizer
readings are achieved.

8.0 Control Functions

8.1 Control Panel

A. LED Display: Can
display current water tem-
perature (default display),
water temperature set point,
selected filter/heating mode,
and error messages.
B. Warmer ( + ) Button:
Increases water tempera-
ture set point.
C. Cooler ( - ) Button:
Decreases water tempera-
ture set point.
Page 18
A
B
C
D
2-Pump J-335/J-345/J-355/J-365 Control Panel
A
B
C
1-Pump J-315/J-325 Control Panel
H
G
F
E
G
F
D