Important Spa Owner Information - Jacuzzi J-315 Owner's Manual

1.0 Important Spa Owner Information

Your Jacuzzi® spa is constructed to the highest standards and is capa-
ble of providing many years of trouble-free use. However, because heat
retentive materials are utilized to insulate the spa for efficient operation,
an uncovered spa surface and wall fittings directly exposed to sunlight
and high temperatures for an extended period is subject to permanent
damage or discoloration. Damage caused by exposing the spa to this
abuse is not covered by warranty. We recommend that you always keep
the spa full of water when it is exposed to direct sunlight and that you
keep the Jacuzzi insulating cover in place at all times when the spa is
not in use. Read and carefully follow the requirements for your spa's
support base found in the section 3.0 titled, "Choosing A Location"
(page 6) or as prescribed by your authorized Jacuzzi dealer.
Jacuzzi spas constantly strives to offer the finest spas available,
therefore, modifications and enhancements may be made which
affect the specifications, illustrations and/or instructions contained
herein.
FCC Notice
This equipment has been tested and found to comply with the limits for
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
1. Rearrange or relocate the receiving antenna;
2. Increase the separation between the equipment and receiver;
3. Connect the equipment into an outlet on a circuit different from the
circuit connected;
4. Consult the dealer or an experienced radio/TV technician for help.
(Changes or modifications not expressly approved by the party
responsible for FCC compliance could void the user's authority to
operate this equipment.)
Page 1