Jacuzzi J-315 Owner's Manual page 2

Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a list
of automated functions performed by your spa. These functions are listed below
in an attempt to suppress any operational concerns you may have during the first
24-hours of ownership! Also listed below are important maintenance recommen-
dations you should observe on a regular basis to protect your new investment.
Automated Operations
Approximately two minutes after power is applied to the spa, the first filtration/
heating cycle turns on pump 1. In J-335, J-345, J-355 and J-365 models, an
automatic five minute "blow-out" function also activates pump 2 for a period of
five minutes to flush all lines. Then, after five minutes, pump 2 turns off and pump
1 continues to operate for the duration of the cycle. Note: this function only
occurs during the first filtration/heating cycle each day.
Maintain Healthy Spa Water
Always maintain your spa's water chemistry within the following parameters as
defined by the Association of Pool And Spa Professionals/USA:
pH
Free Chlorine
Free Bromine
Total Alkalinity
Calcium Hardness
Always maintain your spas filter as outlined below to ensure
healthy spa water. Refer to page 33 "Water Quality Maintenance" for additional
information.
Required Filter Maintenance
Your new spa is equipped with an advanced water filtration system that provides
unsurpassed water quality! To ensure maximum water quality at all times, you
should clean the filter cartridge every three months, or earlier as necessary. See
page 27-28 for detailed filter cartridge cleaning/replacement instructions.
Required Water Replacement
You should replace the spa's water every 3 months. The frequency depends on
a number of variables including frequency of use, number of users, and attention
paid to water quality maintenance. You will know it is time for a change when you
cannot control sudsing and/or you can no longer get the normal feel or sparkle to
the water, even though the key water balance measurements are all within the
proper parameters. See page 33 for additional information.
7.4-7.6
3.0-4.0 ppm
2.0-4.0 ppm
100-120 ppm
150-250 ppm