Panel Displays Col; Panel Displays Ice; Panel Displays; Troubleshooting Procedures - Jacuzzi J-315 Owner's Manual

To Correct Condition:
1. Check for proper water level. Water should be 1" below lowest
pillow.
2. Check for clogged/excessively dirty circulation pump filter cartridge
(control panel side). See section 11.1 (page 27).
3. Purge "air lock" from circulation pump intake by removing its filter
cartridge (control panel side). Place your garden hose over the
heater return wall fitting near the underwater spa light (sec. 8.2,
page 20). Turn-on water for 30 seconds, then turn off. Reinstall filter
cartridge and check spa. See section 11.1 (page 27).
3. If problem persists, contact your authorized Jacuzzi dealer.

13.6 Panel Displays COL

Cool Condition - Temperature has dropped 20°F (11°C)
below the current set temperature. The pump and heater
have been activated to bring the temperature to within 15°F
(8°C) of the set temperature. No corrective action is required. Note:
during cold periods, you may consider increasing the number of filtration
cycles.

13.7 Panel Displays ICE

Freeze Protection - A potential freeze condition has been
detected. No action is required. Main pump #1 will operate to
circulate warm water through the plumbing until the spa is out
of danger.

13.8 Panel Displays - - -

The safety "Watchdog" software has been triggered and
the spa is deactivated. A problem has been detected which
could cause damage to the spa or its components. Contact
your authorized Jacuzzi dealer.

14.0 Troubleshooting Procedures

In the event your Jacuzzi® spa is not working the way it should, please
first review all the installation and operating instructions in this manual
and check the message on the panel display. If you are still not satis-
fied it is working properly, please follow the appropriate troubleshooting
instructions. Note: If any of the supply cords to the accessories are dam-
aged, they must be replaced by an authorized Jacuzzi dealer or service
personnel.
Page 36