Control Functions; Control Panel - Jacuzzi J-230 Owner's Manual

J-200 Series

9.0 Control Functions

9.1 Control Panel

A. LED Display: Can
display current water
temperature (default
display), water temper-
ature set point, selected
filtration/heating mode,
and error messages.
B. Heat Indicator: Lit
when heater is on.
C. Jets 1 Button: Turns jets pump #1 on and off. Press once for low speed;
press a second time for high speed; press a third time to turn pump off.
D. Jets 2 Button: Turns high-speed jets pump #2 on and off. Press once to turn
pump #2 on; press a second time to turn pump #2 off.
E. Light Button Options:
• With standard incandescent light: Turns underwater light on and off.
• With optional LED lighting system: Turns underwater light and top rim
accent lights on in one of three random modes or one of seven solid colors.
Refer to section 10.4 (page 23) for details.
F. Warmer ( ) Button: Increases water temperature set point.
G. Cooler ( ) Button: Decreases water temperature set point.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default setting
is 100°F (38°C).
• Standard light system: Incandescent light runs for 1 hour, then automati-
cally shut off for increased bulb life.
• Optional LED light system: All LED lights run for 1 hour, then automati-
cally shuts off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when activated, then
turn off automatically to conserve energy. Simply press either jets button to
continue operation for an additional 20 minutes.
20
C C
D D
1 1
E E
2 2
A A
B B
G G
F F