Spa Maintenance; Cleaning The Filters - Jacuzzi J-315 Owner's Manual

Example: the "F3" filtration/heating cycle was enabled prior to choosing
lock mode. The spa continues to perform the "F3" cycle until lock mode
is canceled, allowing another cycle to be selected.
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power to
the spa and turn it back on again at 9:58 AM. Note: start time is approx-
imate and may vary slightly from day to day.

11.0 Spa Maintenance

Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Jacuzzi dealer can supply you with
all the information, supplies, and accessory products you will need to
accomplish this.

11.1 Cleaning The Filters

Your Jacuzzi spa is equipped with a skimmer bag and two high
performance filter cartridges located inside the filter skimmer. Fine
debris are filtered by the circulation pump drawing water through the
skimmer bag and circulation pump cartridge. Larger debris are filtered
by the 2-speed jets pump #1 drawing water through the skimmer
bag and main pump cartridge during normal operation and at each
filtration/heating cycle. The skimmer bag and filter cartridges provide
unsurpassed water quality by trapping surface and suspended particles.
An optional chemical feeder is available through your
authorized Jacuzzi dealer that installs under the filter cap
(#2472-673). Always remove the chemical feeder cap and
feeder (when used) during the filter cleaning process by
turning the cap handle counterclockwise. Reinstall the cap
and feeder back onto the filter cartridge after the filter cleaning process
is complete. To avoid touching the chemical feeder, it is recommended
that latex gloves be used during this process. Note: when used,
the chemical feeder MUST remain on the circulation pump filter
cartridge! This filter cartridge is the one with the grid
across the wall fitting as shown (right).
The J-335, J-345, J-355 and J365 models include filters on their
footwell suction covers that prevent debris from entering pump
#2, when operating. These filters must remain in place to protect
Page 27