Functions Of The Web Server - Siemens SITOP UPS1600 Manual

Grayed out menus
If the SITOP UPS1600 was assigned a SIMATIC S7 control as I/O device, or the
SITOP UPS Manager is connected to the SITOP UPS1600, then the web server is in the
read-only mode. The following applies in the read-only mode:
● No write access is possible; the parameter settings can only be read (input values shown
in gray, valid for software version up to V2.0)
● Firmware cannot be updated, the item is hidden.
3.7.3

Functions of the web server

The functions of the web server are split up between the two menus "Diagnostics" and "HW
Configuration".
Use the "Download to device" function to load changes that you have made to the device,
see Loading the configuration (Page 141).
Diagnostics
You can find the following submenus here:
● Alarms:
For an overview of past and active alarms, see Alarm monitoring (Page 141).
● Operating data:
For an overview of the operating data, see View the data of the SITOP UPS1600 (basic
device) (Page 143) and Viewing the energy storage data (Page 144)
● Online functions with the options:
– Firmware update
– Reset to factory setting
For the online functions, see Online functions (Page 145).
HW configuration
Here, in the following areas you can make changes:
● Configuring the PROFINET interface, see General (Page 146)
● Changing the web server settings, see Web server (Page 148)
● Configuring the OPC UA interface, see OPC UA server (Page 149).
● Making PN security settings, see Improved PN security (Page 151).
● Managing users, see User administration (Page 151).
● Configuring basic devices and energy storage devices, see Device configuration
(Page 153)
You can save the configurations and load the existing configurations into the device, see
Load / Save (Page 157).
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
Engineering and remote access
3.7 Web server
139