Siemens SITOP UPS1600 Manual page 99

Data
Start from battery
Selected battery profile
0x0008: Buffering parameters (reading/writing)
Data
Expected buffer current [0.1 Ah]
from V2.0 and higher
0x0009: Maintenance parameters (reading/writing)
Data
Resistor test interval [1 h] from
V2.1
0x0010: DC-UPS command (writing)
Data
CommandID
Parameter 1
Parameter 2
Data
CommandID
Parameter 1
Parameter 2
Data
CommandID
Parameter 1
Parameter 2
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
Description
Start from battery: Setting at the signal terminal for function "Start
from battery".
Profile of the selected battery: The battery charging behavior is set
at the signal terminals. The setting is only used, if the
SITOP UPS1600 is not in the "Remote Enable" (REN) mode
Description
Expected buffer current: Estimated average load current during
buffer operation.
Description
R test interval
Description
Remote reset: 8195
Not used
T : output voltage down time [s]
off
>= V1.0
Description
Remote reset 2: 8207
T : Waiting time after end of communication [s]
d
T : output voltage down time [s]
off
>= V2.0.0
Description
Output ON/OFF: 8200
0
0: output OFF
1: output ON
Engineering and remote access
3.5 Cyclic and acyclic data
Data type
Unsigned8
Unsigned8
Data type
Unsigned16
Data type
Unsigned16
Data type
Unsigned16
Unsigned8
Unsigned8
Data type
Unsigned16
Unsigned8
Unsigned8
Data type
Unsigned16
Unsigned8
Unsigned8
99