Siemens SITOP UPS1600 Manual page 64

Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
Changing the PROFINET device name of the SITOP UPS1600 via the properties of the PROFINET
interface
You can change the PROFINET device name using the properties of the PROFINET
interface.
1. In the Network or Device view of the Hardware and Network editor of STEP 7, select the
PROFINET interface of a PROFINET device.
2. In the Inspector window navigate to "Ethernet addresses" in the "PROFINET" area.
3. Deactivate the "Generate automatically the PROFINET device name" checkbox.
4. Enter the new PROFINET device name in the appropriate field.
Changing the IP address of a SITOP UPS1600
1. In the Network or Device view of the hardware and network editor from STEP 7 in the TIA
Portal , select the PROFINET interface of a PROFINET device.
2. In the Inspector window, navigate to "Ethernet addresses" in the "IP protocol" area.
3. Check whether the "Set IP address in the project" option is activated.
4. Enter the new IP address in the appropriate field.
Loading the configuration to the SITOP UPS1600
To commission the UPS, you must load the project data that you created offline into the
connected SITOP UPS1600. This project data results from the configuration of the hardware,
networks and connections in STEP 7.
Initially, the complete project data is loaded. Only the changes are loaded for subsequent
load actions.
Preconditions
● The project data is consistent.
● The device name must be identical offline and online.
● The SITOP UPS1600 is accessible online.
● The SITOP UPS1600 is located in the PROFINET IO system of an IO controller.
● The PG/PC is connected to the same network to which the SITOP UPS1600 and the
controller are connected. The interface of the PG/PC must be set to TCP/IP.
64
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76