Set A Manual Ipv6 Address (Optional) - DataCard CR805 Installation And Administrator's Manual

c.
Press E
The IP Mode must be set to DualStack to allow any of the following settings to
be used. If you want to use IPv4-only in the future, change the IP Mode to IPv4.
The printer retains the IPv6 settings specified below, but they are not used. This
allows you to return to IPv6 at a later time.
3.
Press the down arrow until the type of addressing you
want to enable displays on line 2.
DHCPv6

SLAAC

Manual

The printer can have multiple IPv6 addresses, depending on your network
environment. All of the IPv6 addresses can be used to access the printer.
4.
Press E
NTER
5.
Press the arrow keys to enable the IPv6 address method.
6.
Press E
NTER
If you enabled DHCPv6 or SLAAC, the printer automatically
obtains one or more IP addresses. If you want to enter a manual
IP address, refer to

Set a Manual IPv6 Address (Optional)

If you want the printer to keep the same IPv6 address at all times, you can enter a manual
address using the Configuration menu. (This is similar to setting a static IPv4 address.)
You also can enter the IPv6 address using Printer Manager. You must access Printer
Manager using IPv4 before you can set the IPv6 address. The Printer Setting >
Communication menu allows you to type the IPv6 address information instead of
using the LCD panel. Refer to
1.
Obtain the following values from your network support personnel. Make sure that you
receive all values:
IPv6 address

IPv6 subnet prefix length

Gateway address

34
to set the IP Mode.
NTER
to open the selected address menu.
to confirm your selection.
"Set a Manual IPv6 Address
""Communication"
(Optional)".
on page 70.
Printer Installation