Set The Ip Address, Subnet Mask, And Gateway Address - DataCard SP25 Plus Printer Manual

Set the IP Address, Subnet Mask, and Gateway Address

Tips for Success
•
The printer address mode must be "Static IP" to set these values. (If the address mode is DHCP, "IP
Addresses" does not appear in the menu.)
•
The menu system moves from one value to the next because these values are related and a change in the IP
address usually leads to a change in the subnet mask (and sometimes in the gateway address).
•
If you need to change just one value, you can scroll to the value you need to change in step 2 below.
1
With "Configuration" displayed on line 1, press the Up or Down Arrow key if needed
to display "IP Addresses" on line 2.
2
Press the Enter key to choose the "IP Addresses" list. "IP Address" is displayed on
line 2.
3
Press the Enter key. The printer shows the current IP address and a cursor
appears under the first byte of the address. (The address byte shows 3 digits when
it can be changed and the cursor appears under the right-most digit.)
Page 58