DataCard CR805 Installation And Administrator's Manual page 108

Description
24) Hopper1CardNumber
OfImpresses
25) ImpresserMaterial
26) ImpresserSpeed
27) L1CoolingTime
28) L2CoolingTime
29) RetransferImpressDepth
Offset
30) RetransferImpressDwell
TimeOffset
31) RollerTypeInstalledL1
32) RollerTypeInstalledL2
Change settings as needed, and then click Set Current to apply changes.
DebowDelay—Specify the amount of time (in milliseconds) to wait before the debow action

takes place if the card also is being impressed. This value is valid only if an impresser is
installed in the laminator. Set this value to 0 if no delay is required.
Exception Card Settings
Use the following settings when an exception job is sent. These may differ from the settings
specified for cards picked from the input hopper. For example, the card material may be different
or you are laminating a preprinted card. You may need to laminate multiple cards to determine
the best settings to use in your environment.
Exception Card Debow Settings:
ExceptionCardDebowDirection—Set the direction of the debow action in the laminator to

return the card to its proper shape after an overlay is applied. A card may become bowed
slightly due to heat from the laminator.
Down—The debow arms in the laminator press down on the card.

Up—The debow arms press up on the card.

92
Current Value
Default Value (unit)
1 1
Overlay Overlay
893 893
0 0
1000 1000
0 0
3000 3000
Standard Rubber
Standard Rubber
Allowed Range
[1 – 3]
[50 – 2000]
[0 – 20000]
[0 – 20000]
[-250 – 250]
[-5000 – 5000]
Printer Manager