Table of Contents
Advertisement
External SCSI interface
Figure 58: Connecting the SCSI cable to the system board
Ê Connect the SCSI cable to the connector SCSI B on the system board (see
arrow).
Route the cable as shown in the figure.
V
CAUTION!
Make sure that the cable is not kinked and not under stress.
Ê Install the fan box and the fan box air duct.
Ê Push the fans back.
Ê If a ROMB upgrade kit is incorporated in the server, install again the cache
module.
V
CAUTION!
Do not press on the battery (BBU) when inserting the cache module.
This may damage the socket. Always hold the cache module by their
edges.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter „Completion" on page
RX300 S2
Installing the external SCSI interface
107.
Options Guide
81
Advertisement
Table of Contents
