Procedure - Fujitsu PRIMERGY RX300 S2 Options Manual

2

Procedure

V
CAUTION!
The actions described in these instructions should only be performed by
technical specialists or service personnel. Equipment repairs should only
be performed by authorized, qualified staff. Any unauthorized opening
and improper repairs could expose the user to risks (electric shock,
energy hazards, fire hazards) and could also damage the equipment.
Please note that any unauthorized opening of the device will result in the
invalidation of the warranty and exclusion from all liability.
Ê First of all please familiarize yourself with the safety instructions in the
chapter „Safety notes" on page
Ê Ensure that all required manuals (see
server" on page
will definitely need the Operating Manual for the server and the Technical
Manual for the system board.
Ê Shut down the server correctly, switch it off, pull out the power plug, and
open the server as described in the
Ê Extend or upgrade your server as described in the relevant chapter.
I
The Operating Manual for the server describes how you
install/remove the hot-plug components.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter „Completion" on page
Ê Start the operating system and, if necessary, configure it as required (see
the Operating Manual).
RX300 S2
15.
8) are available, printing out the PDF files if necessary. You
Options Guide
„Additional documentation about the
chapter „Preparation" on page
107.
21.
13