RemoteView components
Figure 49: Connecting cables to the system board
Ê Connect the power cable (1) and the data cable (2) to the RSB S2 LP.
Ê Install the RSB S2 LP into PCI slot 3, 4 or 5 (described in
controller in a low-profile slot" on page
slot 6, 7or 8 (described in
page
66) respectively.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter „Completion" on page
RX300 S2
RemoteView Service Board S2 LP
64) and RSB S2 LP 3 HU into PCI
„Installing the PCI controller in the riser card" on
107.
Options Guide
1
2
„Installing a PCI
73