Fujitsu PRIMERGY RX300 S2 Options Manual page 38

Installing a second processor
Figure 18: Installing heat sink
Ê Place the heat sink on the processor.
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
V
CAUTION!
Never install a processor without a heat sink as otherwise the processor
may overheat, causing a shut-down of the system.
Ê Reinstall the ventilation duct over the system fans see
memory" on page
V
CAUTION!
Ensure a correct fit of the airduct and that no damage is caused to the
cables
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter „Completion" on page
38
25.
Options Guide
107.
Processors
chapter „Main
RX300 S2