Options And Upgrade - Fujitsu PRIMERGY RX300 S2 Options Manual

Hide thumbs Also See for PRIMERGY RX300 S2:
Table of Contents

Advertisement

Introduction

Options and upgrade

1.2
Options and upgrade
Second processor
The system board can be upgraded with a second processor. Only processors
of the same type may be used on the system board. The second processor must
have the same clock frequency and the same cache as the first processor.
Upgrading of the main memory
The eight slots for the main memory are suitable for PC2-3200 DDR DIMM
memory modules. The organization in four memory banks, 0 to 3, permits rapid
memory access with two-way interleaving.
Memory modules must always be incorporated in pairs. A memory bank must
always be equipped fully with the same type of memory modules.
ROMB (RAID on motherboard)
The System is extended with an on board Intel I/O processor. If the controller is
activated, the on-board 2 channel U320 SCSI-Controller supports RAID Level
0, 1, 10, 5 and 50 on both SCSI channels
"MegaRaid PCI Express™ ROMB" can be activated with two different
upgrading kits.
Additional accessible drives
One 3.25-inch bay and one 3,5-inch bay are available for accessible drives.
One 5.25-inch bay can be installed with a 3.5 inch x 0.5 inch floppy disk drive or
a LocalView module and the other bay can be installed with a 5.25-inch x 0,5
inch DVD-ROM drive.
Options Guide
9
RX300 S2

Advertisement

Table of Contents
loading

Table of Contents