Brother QL-1060N Service Manual page 68

(4) Insert the two hooks A of the front cover into the holes of the cutter unit ASSY.
(5) Catch the hook B of the front cover with the under cover, and assemble it.
(6) Secure the front cover by tightening the two screws (taptite, bind B M3x8) from the bottom
of the machine.
Screw
Under cover
Hook B
Front cover
Note: Put the cover sensor arm L into the gap between the cutter unit ASSY and front
side cover before assembling the front cover.
Front side cover
Fig. 3.2-22 Installing the Front Side Cover, Panel Cover and Front Cover (4)
Screw
Hooks A
Cutter unit ASSY
III- 40
Front cover
Cutter unit ASSY