Brother QL-1060N Service Manual page 43

(9) Remove the shield plate ASSY from the under cover.
Shield plate ASSY
Fig. 3.1-18 Removing the Power Supply PCB and Main PCB (7)
(10) Release the hooks on both sides of the inlet and pull the inlet to the direction of the
arrow as shown in the figure below to remove it.
Note: For the hook on the lower side of the inlet, turn the under cover upside down and
press the hook from the hole on the under cover.
Hole
Fig. 3.1-19 Removing the Power Supply PCB and Main PCB (8)
Under cover
Hook
Inlet
Hook
Hook
III- 15
Under cover