Cisco 10000 Series Configuration Manual page 98

Per-Session Shaping Using RADIUS
Command
Step 8
shape average mean-rate [[burst-size]
[excess-burst-size]] [account {qinq | dot1q |
user-defined offset} aal5 subscriber-encap]
Example:
Router(config-pmap-c)# shape average 10000
Step 9
service-policy policy-map-name
Example:
Router(config-pmap-c)# service-policy child
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
6-8
Chapter 6
Purpose
Shapes traffic to the indicated bit rate.
average is the maximum number of bits sent out in each
interval. Available only on the PRE3.
mean-rate is the committed information rate (CIR) in bits
per second.
(Optional) burst-size is the number of bits in a measurement
interval (Bc).
(Optional) excess-burst-size is the acceptable number of
bits permitted to go over the Be.
(Optional) account enables ATM overhead accounting.
This keyword is required if you configure ATM overhead
accounting.
qinq specifies queue-in-queue (qinq) encapsulation as the
BRAS-to-DSLAM encapsulation type for ATM overhead
accounting.
dot1q specifies IEEE 802.1Q VLAN encapsulation as the
BRAS-to-DSLAM encapsulation type for ATM overhead
accounting.
user-defined indicates that the router is to use the specified
offset size when calculating ATM overhead.
offset specifies the offset size the router is to use when
calculating ATM overhead. Valid values are from -48 to 48
bytes.
aal5 specifies the ATM Adaptation Layer 5 service for ATM
overhead accounting. AAL5 supports connection-oriented
variable bit rate (VBR) services.
subscriber-encap specifies the encapsulation type at the
subscriber line: snap-rbe, mux-rbe, snap-dot1q-rbe,
mux-dot1q-rbe, snap-pppoa, mux-pppoa, snap-1483routed,
mux-1483routed.
Applies the child policy map to the parent class-default
class.
policy-map-name is the name of the child policy map.
RADIUS-Based Shaping and Policing
OL-14660-03