Cisco 10000 Series Configuration Manual page 159

Chapter A ANCP Command Reference
Table 0-2
Field
Flags
virtual-access
virtual-template
VCmode
OAM Cell emulation The status of the OAM cell emulation functionality. It is either enabled or
F5 end2end AIS
xmit frequency
OAM frequency
OAM retry
frequency
OAM up retry count Number of consecutive end-to-end F5 OAM loopback cell responses that must
OAM down retry
count
OL-14660-03
show atm pvc Field Descriptions (continued)
Description
Bit mask describing VC information. The flag values are summed to result in
the displayed value:
0x40—SVC
•
0x20—PVC
•
0x10—ACTIVE
•
0x0—AAL5-SNAP
•
0x1—AAL5-NLPID
•
0x2—AAL5-FRNLPID
•
0x3—AAL5-MUX
•
0x4—AAL3/4-SMDS
•
0x5—QSAAL
•
• 0x6—ILMI
• 0x7—AAL5-LANE
• 0x9—AAL5-CISCOPPP
Virtual-access interface identifier.
Virtual template identifier.
AIP-specific or NPM-specific register describing the usage of the VC. This
register contains values such as rate queue, peak rate, and AAL mode, which
are also displayed in other fields.
disabled.
Number of seconds between transmission of AIS cells.
Number of seconds between transmission of OAM loopback cells.
Frequency (in seconds) at which end-to-end F5 loopback cells should be sent
when a change in state (up or down) is being verified. For example, if a PVC is
up and a loopback cell response is not received after the value of the frequency
argument (in seconds) specified using the oam-pvc command, loopback cells
are sent at the value of the retry-frequency argument to determine whether the
PVC is down.
be received in order to change a PVC state to up. Does not apply to SVCs.
Number of consecutive end-to-end F5 OAM loopback cell responses that if not
received, change a PVC state to down or tear down an SVC.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
show atm pvc
A-27