Cisco 10000 Series Configuration Manual page 119

Chapter 7 Traffic Accounting
Command
Step 9
(Continued)
[
shape average] mean-rate
[
excess-burst-size
user-defined offset} aal5 subscriber-encap]
Example:
Router(config-pmap-c)# shape average 8000
account dot1q aal5 snap-pppoa
Step 10
service-policy policy-map-name
Example:
Router(config-pmap-c)# service-policy child
Step 11
exit
Example:
Router(config-pmap-c)# exit
Step 12
exit
Example:
Router(config-pmap)# exit
Applying the QoS Policy to a Virtual Template Interface
Use the following procedure to apply the QoS policy with ATM overhead accounting to a virtual
template interface.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
OL-14660-03
[ ]
burst-size
] [
account {qinq | dot1q |
interface virtual-template number
(Optional) ip unnumbered interface-type interface-number
(Optional) ppp authorization [default | list-name]
(Optional) ppp accounting [default | list-name]
(Optional) ppp authentication {chap | pap | chap pap | pap chap} [if-needed] [list-name |
default] [callin]
service-policy output policy-map-name
exit
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Purpose
subscriber-encap specifies the encapsulation type at the
subscriber line. Valid values are:
• SNAP-RBE, SNAP-PPPoA, SNAP-PPPoE, and
SNAP-IP
MUX-RBE, MUX-PPPoA, MUX-PPPoE, and MUX-IP
•
Applies the child policy to the parent class-default class.
policy-map-name is the name of a previously configured
child policy map.
Do not specify the input or output keywords when
Note
applying a child policy to a parent class-default
class.
Exits policy-map class configuration mode.
Exits policy-map configuration mode.
Layer 2 Overhead Accounting
7-7