Cisco 10000 Series Configuration Manual page 134

aaa connect-info
aaa connect-info
To configure connection information (RADIUS Attribute 77) as the identifier at either the ATM VC or
Gigabit Ethernet subinterface level, use the aaa connect-info. To deconfigure RADIUS Attribute 77 as
the identifier, use the no version of this command.
ATM
Syntax Description
string
Command Default The default is the same as having the no aaa connect-info command configured.
Command Modes
•
•
•
•
•
Command History
Release
12.2(31)ZV0d
Usage Guidelines
Specify characteristics of the subscriber in the command's string argument to easily recognize policy
information for a connection. For example:
aaa connect-info subscriber_specific_info
The router rejects the command if the string exceeds 64 characters.
Examples
This example shows the configuration of the connect-info (RADIUS Attribute 77) as the identifier under
a Gigabit Ethernet subinterface. The string indicates that the connection speed is 25100 Kbps.
Router(config)# interface GigabitEthernet4/1/0.2
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-2
aaa connect-info string
no aaa connect-info string
no aaa connect-info
An ASCII string with up to 64 characters that specifies the connection
information sent through Attribute 77.
Gigabit Ethernet Subinterface mode
ATM PVC mode
ATM PVC range mode
ATM PVC-in-range mode
ATM VC-CLASS mode
Router(config-subif)# aaa connect-info speed25100
Modification
This command was introduced on the Cisco IOS 10000 series
router.
Chapter A ANCP Command Reference
OL-14660-03