Cisco 10000 Series Configuration Manual page 139

Chapter A ANCP Command Reference
ancp enable
To enable Access Network Control Protocol (ANCP) on a specific IP-enabled interface or subinterface,
use the ancp enable command in interface or subinterface configuration mode. To disable ANCP, use
the no form of this command.
Do not configure ancp enble prior to configuring all the ancp neighbor commands because the access
Note
node connecting to the BRAS (where ancp enable is configured) relays an ANCP Port UP events related
to the interfaces. If the ancp neighbor command for this interface is not configured, the client-ID in the
ANCP Port UP is not matched, and the message is discarded.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled
Command Modes Interface
Subinterface
Command History Release
12.2(28)ZV
12.2(31)ZV1
Usage Guidelines You must configure the ancp enable command on an interface or subinterface on which IP is configured.
Examples The following example shows how to enable ANCP on Gigabit Ethernet subinterface 1/0/1.2:
interface GigabitEthernet1/0/1.2
ip address 10.0.75.123 255.255.255.0
ancp enable
Related Commands Command
ancp adjacency timer
ancp atm shaper
ancp neighbor
OL-14660-03
ancp enable
no ancp enable
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
This command was modified for Access Network Control Protocol (ANCP),
replacing L2CP.
Description
Specifies the interval between ANCP hello messages.
Enables ANCP cell tax accounting for ATM U-interface connections.
Specifies the ANCP access node neighbor (DSLAM).
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
ancp enable
A-7