Cisco 10000 Series Configuration Manual page 22

Configuring Access-Network Control Protocol
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ancp atm shaper percent-factor factor
Example:
Router(config)# ancp shaper percent-factor 95
Step 4
interface atm slot/subslot/port.subinterface
Example:
Router(config)# interface atm 2/0/1.1
Step 5
pvc vpi/vci
Example:
Router(config-subif)# pvc 1/101
Or
range pvc {start-vpi/start-vci}
{end-vpi/end-vci}
Example:
Router(config-subif)# range pvc 9/100 9/102
pvc-in-range vpi/vci
Example:
Router(config-if-atm-range)# pvc-in-range 9/100
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
1-10
pvc [vpi] [vci] or pvc-in-range [vpi] [vci]
ancp neighbor name dslam-name id dslam-id client-ID port-y-identifier
Chapter 1
Purpose
Enables privileged EXEC mode. If prompted, enter your
password.
Enters global configuration mode.
Enables ANCP cell tax accounting for ATM U-interface
connections
Enters interface configuration mode for the specified ATM
subinterface.
Creates a one-to-one mapping between a PVC and DSLAM
port and enters ATM virtual circuit configuration mode.
This command is available under pvc and pvc-in-range
command modes.
• range pvc: defines a range of ATM permanent virtual
circuits (PVCs). Use this command in the subinterface
configuration mode.
pvc-in-range:configures an individual (PVC) within a
•
PVC range.
Access-Network Control Protocol
OL-14660-03