Auto Calibration Procedure - Vision Fitness T60 Service Manual

3.3 AUTO CALIBRATION PROCEDURE

AUTO CALIBRATION PROCEDURE:
The Vision Fitness T60 should be auto calibrated after assembly, the replacement of any electronic component, or the replacement of the incline
motor. Follow the procedure below to run auto calibration. If the auto calibration fails, contact Vision Fitness Customer Technical Support.
1) Hold the INCLINE DOWN and SPEED DOWN keys simultaneously for 3-5 seconds. The instruction center on the console should display
Manager Mode.
2) Scroll through the list of Manager Mode settings using the SPEED UP or DOWN keys until P16 Auto Check shows in the instructions
center on the console.
3) Press the Select key to begin an Auto Calibration. This will test the incline range of the treadmill.
4) Once Auto Calibration is complete (the instruction center should say passed or failed), press and hold the RESET key to return to normal
operation.
If the auto calibration fails, contact Vision Fitness Customer Technical Support.
CHAPTER 3: PREVENTATIVE MAINTENANCE
7