Troubleshooting - No Power To The Console - Vision Fitness T60 Service Manual

6.17 TROUBLESHOOTING - NO POWER TO THE CONSOLE

POSSIBLE CAUSES:
1) The unit is not getting power from the outlet.
2) The MCB is not getting power from the power receptacle.
3) The MCB LEDs are lit, but there is no power to the console.
SOLUTION:
1-2) Remove the front cover and check to see if LED 12V is lit on the MCB (Figure A).
a. If it is not, verify power at the outlet.
b. If LED 12V is still not lit after verifying outlet power, replace the power components (cord, switch, receptacle).
c. If the replacing the power components does not resolve the issue, replace the MCB.
3) Check to see if LED11 is lit on the UCB (Figure B).
a. If LED11 is lit, the console should be on. If not, replace the UCB.
b. If LED11 is not lit, check the connection of the console cable. Use a multi-meter to measure voltage across pins 1 and 3 of the console
cable. There should be a reading of around 12V. Replace the console cable if this voltage is not seen. If the voltage is correct, replace the
UCB.
FIGURE A
CHAPTER 6: TROUBLESHOOTING
NO POWER TO THE CONSOLE
FIGURE B
27