Auto-Calibration - Vision Fitness T9700 Simple Owenrs Manual

AUTO-CALIBRATION

AUTO-CALIBRATION
AUTO-CALIBRATION AUTO-CALIBRATION AUTO-CALIBRATION
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION! DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION! DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION! DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION! DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!
You need to access User Engineering Mode to run the Auto Calibration. To access
this mode, please hold down SPEED DOWN and SELECT for 5 seconds. When in
" U S E R E N G " " U S E R E N G " " U S E R E N G " appears in the alphanumeric window. Press SELECT. To
the User mode, " U S E R E N G " " U S E R E N G "
access the data press either set of arrow keys until " A U T O - C A L I B R A T I O N "
Press SELECT.
To begin auto-cal, press START. The Treadmill will run through minimum and maxi-
mum speed and maximum incline. This will take 3-5 minutes. Let the Treadmill
perform this complete function before exiting the Engineering Mode.
" E N D " " E N D "
" E N D " " E N D " will appear when the auto-calibration is complete. The Treadmill will come to " E N D "
a complete stop and return to the start-up screen in the alphanumeric window.
P22 - EXIT USER ENGINEERING MODE P22 - EXIT USER ENGINEERING MODE P22 - EXIT USER ENGINEERING MODE P22 - EXIT USER ENGINEERING MODE P22 - EXIT USER ENGINEERING MODE
P22 represents exit mode. When you press SELECT, the console performs a reboot,
returning to program setup.
" A U T O - C A L I B R A T I O N " appears. " A U T O - C A L I B R A T I O N " " A U T O - C A L I B R A T I O N " " A U T O - C A L I B R A T I O N "
48 48 48 48 48