Incline Motor Replacement - Vision Fitness T60 Service Manual

7.10 INCLINE MOTOR REPLACEMENT

1) Turn off power and remove the power cord from the unit.
2) Remove the motor cover as outlined in Section 7.1.
3) Lift up the treadmill and support the front end so that the front wheels are off of the floor (Figure A). The treadmill could also be tipped on its
side.
4) Remove the bolt attaching the incline motor to the rack (Figure B).
FIGURE A
5) Disconnect the incline motor cable from the MCB (Figure C).
6) Disconnect the incline motor from the top mounting bracket (Figure D).
FIGURE C
7) Lift the incline motor away from the treadmill (Figure E).
8) Reverse Steps 1-7 to install a new incline motor. NOTE: Be sure to re-install the washers at the top and bottom connection points.
9) Test the treadmill as outlined in Section 7.15.
CHAPTER 7: PART REPLACEMENT GUIDE
FIGURE E
FIGURE B
FIGURE D
37