Cisco Nexus 5500 Series Command Reference Manual page 78

Nx-os security command reference
Hide thumbs Also See for Nexus 5500 Series:
Table of Contents

Advertisement

deny udp (IPv4)
Address and network wildcard-You can use an IPv4 address followed by a network wildcard to
specify a host or a network as a source or destination. The syntax is as follows:
IPv4-address network-wildcard
This example shows how to specify the source argument with the IPv4 address and network wildcard
for the 192.168.67.0 subnet:
switch(config-acl)# deny udp 192.168.67.0 0.0.0.255 any
Address and variable-length subnet mask-You can use an IPv4 address followed by a
variable-length subnet mask (VLSM) to specify a host or a network as a source or destination. The
syntax is as follows:
IPv4-address/prefix-len
This example shows how to specify the source argument with the IPv4 address and VLSM for the
192.168.67.0 subnet:
switch(config-acl)# deny udp 192.168.67.0/24 any
Host address-You can use the host keyword and an IPv4 address to specify a host as a source or
destination. The syntax is as follows:
host IPv4-address
This syntax is equivalent to IPv4-address/32 and IPv4-address 0.0.0.0.
This example shows how to specify the source argument with the host keyword and the
192.168.67.132 IPv4 address:
switch(config-acl)# deny udp host 192.168.67.132 any
address. For examples of the use of the any keyword, see the examples in this section. Each example
shows how to specify a source or destination by using the any keyword.
When you specify the protocol argument as udp, the port argument can be a UDP port number, which
is an integer from 0 to 65535. It can also be one of the following keywords:
domain-Domain Name Service (DNS, 53)
echo-Echo (7)
isakmp-Internet Security Association and Key Management Protocol (5)
mobile-ip-Mobile IP registration (434)
nameserver-IEN116 name service (obsolete, 42)
netbios-dgm-NetBIOS datagram service (138)
netbios-ns-NetBIOS name service (137)
netbios-ss-NetBIOS session service (139)
Cisco Nexus 5500 Series NX-OS Security Command Reference
64
Chapter
D Commands
OL-27883-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents