Intermec PEN*KEY 6400 User Manual page 104

Bar Code Parms
The Bar Code Parms (parameters) menus designate:
"
"
"
"
The Scanner Type menu is the first Bar Code Parms menu.
Choose the desired option from this menu and press the
[ENT] key. The next Bar Code Parms menu appears on the
display.
Scanner Type
Use the Scanner Type menu to designate the type of bar
code scanner.
To make a selection, press the numeric key corresponding to
the desired option, then press the [ENT] key. This takes
you to the Scan Options menu.
" NOTE:
You can choose option 1, "No Scanner," and still set the remaining
scanner and bar code options. Then, if you use a scanner at a later
time, all parameters are set and it is only necessary to designate the
scanner type.
" NOTE:
Selected options are highlighted on the display. To deselect a se-
lected option, press the key that corresponds to that option.
SECTION 3
If you are using a bar code scanner
Scan options
The bar code symbologies to use (the computer can
only decode the bar code symbologies you enable)
Options for each enabled bar code symbology (e.g.,
minimum and maximum bar code lengths)
Scanner Type
1) No Scanner
2)
3) Laser
4)
5)
R
PEN*KEY Model 6400 Hand-Held Computer User's Guide
Terminal Emulation Menu Screens
"
3-17