September - Genie Z-40/23N Service And Repair Manual

September 2016

6 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer rocker switch.
Result: The display will show FAULTS.
7 Momentarily activate the steer rocker switch in
the right direction until SETTINGS is shown on
the display.
8 Momentarily activate the drive enable toggle
switch in the right direction to enter the
SETTINGS menu.
Result: The display will show VALVE AND
PUMP SETTINGS.
9 Momentarily activate the drive enable toggle
switch in the right direction to enter the VALVE
AND PUMP SETTINGS menu.
Result: The display will show THRESHOLD
CURRENT.
10 Momentarily activate the steer rocker switch in
the right direction until START PUMP GPM is
shown on the display.
11 Momentarily activate the drive enable toggle
switch in the right direction to begin pump
calibration.
Part No. 1268528
12 Press down on the foot switch. Move and hold
the primary boom rocker switch in the extend
direction until the boom is fully extended and
an audible alarm has sounded.
Result: The alarm sounds. Continue to step
13.
Result: The alarm does not sound. Fully
retract the primary boom and repeat steps
11 and 12.
To exit programming mode:
13 Move and hold the drive enable toggle in the
left position until the display returns to
SYSTEM READY mode.
Z-40/23N, Z-40/23N RJ
Service and Repair Manual
Hydraulic Pump
51