Table of Contents
Advertisement
If you want to install the board holder and a riser card is already installed, note that the
i
riser card is secured by the board holder. When you insert the board holder, make sure
that the riser card is fixed by the angle piece of the board holder.
Installing a board
►
Open the casing (see "Opening the casing").
The locking slider also serves as the fixing bracket for the board on the casing rear panel.
i
You can only install the board if the locking slider has been moved to the right (from rear
view).
Removing the slot cover
4
Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
!
cover (cooling, fire protection or EMC regulations to be complied with).
If you install a board, you must install the board holder to fix the riser card. The board
i
holder has been left out of the drawing to provide a better overview.
►
Make the required settings for the board.
A26361-K1009-Z120-1-7619, edition 4
1
3
►
Remove locking clip (1).
►
Push the slot cover in the direction of the
arrow up to the locking slider (2).
►
Now slide the slot cover (3) inwards into
the casing and remove it from the
casing (4).
System expansions
35
Advertisement
Table of Contents
