Installing And Removing The Riser Card - Fujitsu Siemens Computers Esprimo C Operating Manual

System expansions

Installing and removing the riser card

You can install a riser card either with or without a DVI port. These are installed and removed
differently.
Installing the riser card without a DVI port
So that the riser card is sufficiently secured in case of further system expansions, you
i
must reinstall the board holder after installing the riser card before you make further
changes to the riser card.
Removing the riser card without a DVI port
38
► Open the casing (see "Opening the
casing").
► Place the riser card onto the provided slot
on the main board and press until it
engages. See manual for the mainboard.
► Install the board holder again (see
"Installing the board holder").
► Close the casing (see "Closing the
casing").
► Open the casing (see "Opening the
casing").
► Remove the board holder (see "Removing
the board holder").
► Pull the riser card upward out of the
casing.
► Close the casing (see "Closing the
casing").
A26361-K1009-Z120-1-7619, edition 4