Table of Contents
Advertisement
Replacing lithium battery
In order to permanently save the system information, a lithium battery is installed to provide the
CMOS-memory with a current. A corresponding error message notifies the user when the charge is
too low or the battery is empty. The lithium battery must then be replaced.
Incorrect replacement of the lithium battery may lead to a risk of explosion!
!
The lithium battery may be replaced only with an identical battery or with a type
recommended by the manufacturer.
Do not throw lithium batteries into the household waste. They must be disposed of in
accordance with local regulations concerning special waste.
Make sure that you insert the battery the right way round: The plus pole must be on the
top!
The lithium battery holder exists in different designs that function in the same way.
1
►
Press the catch in the direction of the arrow (1).
The battery jumps out of the holder slightly.
►
Remove the battery (2).
►
Push the new lithium battery of the identical type into the holder (3) and press it downward until
it engages.
Following changes
►
Fold down the drive cage (see "Closing the drive cage").
►
Close the casing (see "Closing the casing").
A26361-K1009-Z120-1-7619, edition 4
2
2
3
System expansions
3
61
Advertisement
Table of Contents
