NETGEAR GC728X User Manual page 360
Insight managed 28-port gigabit ethernet smart cloud switch with 2 sfp 1g & 2 sfp+ 10g fiber ports
Hide thumbs
Also See for GC728X:
- Hardware installation manual (31 pages) ,
- Installation manual (2 pages) ,
- Hardware installation manual (40 pages)
Table of Contents
Advertisement
Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5.
Select Maintenance > Troubleshooting > Traceroute IPv6.
The Traceroute IPv6 page displays.
6.
In the IPv6 Address/Host Name field, enter the IPv6 address or host name of the device for
which the path must be discovered.
7.
In the Probes Per Hop field, enter the number of probes per hop.
The default value is 3. The range is 1 to 10.
8.
In the Max TTL field, enter the maximum time to live (TTL) for the destination.
The default value is 30. The range is 1 to 255.
9.
In the Init TTL field, enter the initial TTL to be used.
The default value is 1. The range is 1 to 255.
10.
In the MaxFail field, enter the maximum number of failures allowed in the session.
The default value is 5. The range is 1 to 255.
11.
In the Interval field, enter the time between probes in seconds.
The default value is 3. The range is 1 to 60.
12.
In the Port field, enter the UDP destination port for the probe packets.
The default value is 33434. The range is 1–65535.
13.
In the Size field, enter the size of the probe packets.
The default value is 0. The range is 0 to 39936.
14.
From the Source menu, select the IP address or interface that must be used to send echo
request packets:
•
None. The source address for the traceroute is the address of the default egress
interface.
•
IP Address. The source IP address that must be used for the traceroute. With this
selection, the IPv6 Address field displays and you must enter the IPv6 address that
must be used as the source.
•
Interface. The interface that must be used for the traceroute. With this selection, the
Interface menu displays and you must select an interface as the source.
15.
Click the Apply button.
A traceroute request is sent to the specified IP address or host name. The results are
displayed below the configurable data in the Results field.
Perform Maintenance Tasks
360
Hide quick links:
Advertisement
Table of Contents
