Service Mode - Roland CAMM-1 PRO CM-500 Service Notes

4 Adjustment

4-2 SERVICE MODE

Move TOOL CARRIAGE fulley to right end.
Turn on the POWER. and press
[SETUP] key within 1 second.
[ ],[ ],[ ] + [SETUP] key
Service mode
ROM MA120 B110
4
[ ],[ ] key to select.
[ENTER] key to carry out.
26
vice mode
MA120 B110
Sensor
F=0 R=0 P=0
Carr.=0 Cover=0
[MENU] key
DRAM
DRAM check [2M]
*******
[MENU] key
EEROM
EEROM check
*******
[MENU] key
Ageing
[ENTER] key
Ageing ready?
Start - ENTER
[MENU] key
Force
Force adjust
[ UP] 20g
[MENU] key
Slider AD:128
[ * ]
[MENU] key
Key
Key test
**********
[MENU] key
Calib.
Select axis
Grit Carriage
[MENU] key
Landing
Select tool
Cutter Pen
[MENU] key
Displays FLASHROM version.
M = main, B = Boot
Checks whether sensor is functioning properly.
SENSOR ON=1/OFF=0, F=FRONT, R=REAR, P=PINCHROLL
Checks whether DRAM is functioning properly.
Checks whether EEROM is functioning properly.
[ 400, 400]
Stop - ENTER
[ENTER] key
[ENTER] key
[ 1, 1]
Start - ENTER
This is for MOTOR BALANCE ADJUSTMENT.
Force adjust
[DOWN] 20g
This is for PEN PRESSURE ADJUSTMENT. (page)
Push panel key in sequence of [MENU],[ENTER],
[ ],[ ],[ ],[ ],[SETUP],[TEST]key to check.
Grit Grit calibration
0.00% - 0.10%
[MENU] key
Carriage
Car. calibration
0.00% - 0.10%
[MENU] key
[SETUP] key
Test draw mode
This is for calibration.
Cut ATK BRK
Cutter
1 -1
[MENU] key
Pen ATK BRK
Pen
0 1
[MENU] key
This is checking softlanding function.
[TEST] key
Land test
plotting..
[TEST] key Land test
plotting..