Using The Reset Button - ZyXEL Communications P-3202HN-Ba User Manual

and streaming video/audio media, all at the same time with no noticeable loss in
bandwidth.
Figure 4 Triple Play Example
1.5 The Reset Button
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "1234".

1.5.1 Using the Reset Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
IAD User's Guide
Chapter 1 Introduction
25