Table of Contents
Advertisement
Chapter 14 Quality of Service (QoS)
Table 51 QoS > General
LABEL
Traffic
priority will
be
automatical
ly assigned
by
Apply
Cancel
14.3 The Class Setup Screen
Use this screen to add, edit or delete classifiers. A classifier groups traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
166
DESCRIPTION
These fields are ignored if traffic matches a class you configured in the
Class Setup screen.
If you select ON and traffic does not match a class configured in the Class
Setup screen, the IAD assigns priority to unmatched traffic based on the
IEEE 802.1p priority level, IP precedence and/or packet length. See
14.5.4 on page 177
for more information.
If you select OFF, traffic which does not match a class is mapped to queue
two.
Click Apply to save your settings back to the IAD.
Click Cancel to begin configuring this screen afresh.
Section
IAD User's Guide
Advertisement
Table of Contents
