Table of Contents
Advertisement
Chapter 20 Tools
After you see a "restore configuration successful" screen, you must then wait one
minute before logging into the IAD again.
The IAD automatically restarts in this time causing a temporary network
disconnect.
If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default device IP
address (10.0.0.138). See
your computer's IP address.
If the upload was not successful, the following screen will appear. Click Return to
go back to the Configuration screen.
20.3.3 Reset to Factory Defaults
Click the Reset button to clear all user-entered configuration information and
return the IAD to its factory defaults. You can also press the RESET button on the
rear panel to reset the factory defaults of your IAD.
20.4 Restart
System restart allows you to reboot the IAD without turning the power off. Click
Maintenance > Tools > Restart. Click Restart to have the IAD reboot. This
does not affect the IAD's configuration.
Figure 116 Restart Screen
222
Appendix B on page 245
for details on how to set up
IAD User's Guide
Advertisement
Table of Contents
