Table of Contents
Advertisement
Chapter 11 Phone Usage
Pick up another phone's receiver. Press "#97#" followed by the same number you
2
entered before to continue the call.
11.5 Checking the IAD's IP Address
Do the following to listen to the IAD's current IP address.
Pick up your phone's receiver.
1
Press "****" on your phone's keypad and wait for the message that says you are
2
in the configuration menu.
Press "5" followed by the # key.
3
Listen to the IP address and make a note of it.
4
Hang up the receiver.
5
11.6 Auto Provisioning and Auto Firmware
Upgrade
If your service provider uses an auto-provisioning server to set up your device,
you must first authenticate your IAD with the auto provisioning server, allowing
you to use the service.
• On a phone connected to the device, enter "*99**", your SIP number, "*", then
"#".
• For example, if your SIP number is 0123456, you would enter
"*99**0123456#".
During auto-provisioning, the IAD checks to see if there is a newer firmware
version (if your service provider activates this feature). If newer firmware is
available, the IAD plays a recording when you pick up your phone's handset.
• Press "*99#" to upgrade the IAD's firmware.
• Press "#99#" to not upgrade the IAD's firmware.
130
IAD User's Guide
Advertisement
Table of Contents
