Lifting The Outboard; Steering Systems - BRP E200HSLSEA Service Manual

Lifting the Outboard

Lifting Fixtures
WARNING
To avoid personal injury, make sure the
lifting capacity of the hoist is at least twice
the weight of the outboard.
DO NOT allow the lift hook or chain from
the hoist to come in contact with any part
of the engine during lifting.
Remove shipping carton.
The mounting hardware used to attach the out-
board to the pallet is reused to fasten outboard to
boat transom.
Use correct Lifting Fixture to lift outboard:
Model
90° V6
Position lifting tool on flywheel and seat the three
screws completely.
1
1. Lifting fixture
2. 1 3/4 in.screws
Fasten appropriate chain hook to eye of tool.
Carefully hoist outboard with chain and unbolt out-
board mounting brackets from frame.

Steering Systems

Mechanical Cables
All Evinrude outboards equipped with tilt tubes are
compatible with mechanical steering systems that
meet ABYC Standard P-17. Single-cable mechan-
ical steering systems can be used on single or
dual-outboard installations if an ABYC-approved
steering link is used.
Dual-cable mechanical steering helps provide firm
steering control at high speeds.
Extend the steering cable and lubricate the inner
core before installation.
Lifting Fixture
P/N 396748
ABYC-approved mechanical steering cable.
IMPORTANT:
tube before mounting outboard on transom.
2
Tighten nut securely.
DO NOT use cable over pulley steering on
40 HP and larger outboards.
002419
INSTALLATION AND PREDELIVERY
OUTBOARD INSTALLATION
Install steering cable through tilt
WARNING
2
5873
49