Oil Pressure Sensor - BRP E200HSLSEA Service Manual

ENGINE MANAGEMENT MODULE (EMM)
EXTERNAL SENSORS
If cylinder head temperature exceeds 194°F
(90°C) above 2000 RPM for 3 seconds, the EMM:
Activates S.A.F.E.
If cylinder head temperature exceeds 248°F
(120°C) for 3 seconds, the EMM:
Activates SHUTDOWN
Stores service code 31
EMM LED 4: FLASHING
Engine Monitor TEMP display: FLASHING
The outboard will not restart until the engine tem-
perature returns to normal. Refer to SHUTDOWN
MODE on p. 102.
If sensor values are less than -13°F (-25°C), or
greater than 329°F (165°C), the EMM:
Stores service code 41 (port sensor)
Stores service code 67 (stbd sensor)
EMM LED 3: OFF (Cranking)
EMM LED 3: ON (Running)
If sensor values are below -4°F (-20°C), the EMM:
Stores service code 42 (port sensor)
Stores service code 68 (stbd sensor)
EMM LED 3: OFF (Cranking)
EMM LED 3: ON (Running)
If cylinder head does not reach operating temper-
ature (122°F / 50°C below 1000 RPM) in 10 min-
utes, the EMM:
Stores service code 58 (port sensor)
Stores service code 59 (stbd sensor)
EMM LED 3: OFF (Cranking)
EMM LED 3: ON (Running)
Shift Interrupt Switch
If the switch is stuck in the closed position, the
EMM:
Stores service code 28
EMM LED 3: ON (Running)
98

Oil Pressure Sensor

The oil pressure sensor monitors oil pressure in
the oil distribution manifold.
If the sensor does not detect pressure for 150
pump cycles, the EMM:
Activates S.A.F.E.
Stores service code 38
EMM LED 4: ON (Running)
Engine Monitor NO OIL display: ON
If outboard has been run for more than 5 hours
with NO OIL faults (codes 34 & 38), the EMM:
Activates SHUTDOWN
Stores a service code 33
EMM LED 4: FLASHING
Engine Monitor NO OIL display: FLASHING
The outboard will restart for one
IMPORTANT:
minute intervals until problem is resolved and
code is cleared. To clear code use the diagnostic
software program.
If the sensor reads out of the expected range, or
the sensor or circuit fails, the EMM:
Stores service code 71
EMM LED 3: ON (Running)
If the sensor circuit indicates below expected
range (<.4 V), the EMM:
Stores service code 72
EMM LED 3: ON (Running)
If the sensor circuit indicates above expected
range (> 4.6 V), the EMM:
Stores service code 73
EMM LED 3: ON (Running)